MCQs in Basic Television - Grob TV - Part II

MCQs in Basic Television - Grob TV - Part II

This is the Multiples Choice Questions Part 2 of the Series in Basic Television - Grob TV as one of the Electronics Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Exam Questions in Electronics Engineering field, Electronics Books, Journals and other Electronics References.

The Series

Following is the list of multiple choice questions in this brand new series:

Basic Television - GROB TV MCQs
PART 1: MCQs from Number 1 – 50                        Answer key: PART I
PART 2: MCQs from Number 51 – 100                   Answer key: PART II
PART 3: MCQs from Number 101 – 152                   Answer key: PART III

Continue Practice Exam Test Questions Part II of the Series

Choose the letter of the best answer in each questions.

51. The R, G, and B video drive controls are set for ________ in the picture.

  • A. dark gray
  • B. white
  • C. black
  • D. green

52. Background controls of many picture tubes are for the

  • A. ac bias
  • B. dc bias
  • C. ac video signal
  • D. dc video signal

53. The G2 master screen control of picture tubes vary the

  • A. ac voltage
  • B. dc voltage
  • C. ac video signal
  • D. dc video signal

54. In the sawtooth waveform for linear scanning

  • A. the linear rise if for flyback
  • B. the complete cycle includes trace and retrace
  • C. the sharp reversal in amplitude produces trace
  • D. the beam moves faster during trace than retrace.

55. Given a 635 us vertical retrace time, the number of complete horizontal lines scanned during vertical flyback is

  • A. 10
  • B. 20
  • C. 30
  • D. 63

56. One-half line spacing between the start position for scanning even and odd fields produces

  • A. linear scanning
  • B. line pairing
  • C. fishtailing
  • D. exact interlacing

57. The number of lines scanned per frame in the raster on the picture tube screen is

  • A. 525
  • B. 262
  • C. 20
  • D. 10

58. In the frame for which interlaced scanning is used, alternate lines are skipped during vertical scanning because

  • A. the trace is slower than the retrace
  • B. the vertical scanning frequency is doubled from 30 to 60 Hz
  • C. The horizontal scanning is slower than vertical scanning
  • D. the frame has a 4 : 3 aspect ratio

59. If the horizontal flyback is 10 percent, this time equals

  • A. 10 us
  • B. 56 us
  • C. 6.4 us
  • D. 83 us

60. Which of the following is NOT true?

  • A. line pairing indicates poor interlacing.
  • B. People look too tall and too thin on a square raster on the picture tube screen.
  • C. A person can appear to have one shoulder wider than the other because of nonlinear horizontal scanning.
  • D. the keystone effect produces a square raster.

61. The width of a vertical sync pulse with its narrations includes the time of

  • A. six half-lines, or three lines
  • B. five lines
  • C. three half-lines
  • D. five half-lines

62. Sawtooth generator circuits produce the scanning raster, but the sync pulses are needed for

  • A. linearity
  • B. timing
  • C. keystoning
  • D. line Pairing

63. Which of the following frequencies is wrong?

  • A. 15,750 Hz for horizontal sync and scanning
  • B. 60 Hz for vertical sync and scanning
  • C. 31,500 Hz for equalizing pulses and serrations in the vertical sync pulses
  • D. 31,500 Hz for the vertical scanning frequency

64. Which of the following is faster in horizontal scanning?

  • A. trace
  • B. retrace
  • C. flyback
  • D. retrace or flyback

65. Which of the following takes more time?

  • A. H retrace
  • B. H trace
  • C. V retrace
  • D. V trace

66. What does an interlaced scanning require for the number of the horizontal lines?

  • A. odd
  • B. Even
  • C. Both odd and even simultaneously
  • D. Either odd or even

67. How many horizontal lines are in the odd or an even field?

  • A. 10 ½
  • C. 525 lines
  • B. 262 ½ lines
  • D. 600 lines

68. How many H lines are there in a complete frame?

  • A. 19 lines
  • B. 21 lines
  • C. 262 ½ lines
  • D. 600 lines

69. How many H lines are there in each field?

  • A. 8 ½ lines
  • B. 10 ½ lines
  • C. 262 ½ lines
  • D. 325 lines

70. How many H lines are there in each V retrace?

  • A. One
  • B. two
  • C. three
  • D. four

71. What are the frequencies of V scanning, V sync, and V blanking?

  • A. 30 Hz
  • B. 60 Hz
  • C. 90 Hz
  • D. 360 Hz

72. What are the frequencies of H scanning, H sync and H blanking?

  • A. 15,750 Hz
  • B. 16,750 Hz
  • C. 31,500 Hz
  • D. 30,050 Hz

73. In video signal analysis, what are the three parts of the composite video signal, for two horizontal lines in the picture?

  • A. Camera signal
  • B. H sync C. H blanking
  • C. H blanking
  • D. all of the above

74. In the IRE scale for composite video signal, list the number of IRE units used for sync, black setup, and the camera signal?

  • A. 40, 7.5, 92.5 respectively
  • B. 92.5, 40, 7.5 respectively
  • C. 7.5, 40, 92.5 respectively
  • D. 92.5, 7.5,40 respectively

75. What are the approximate time periods for the width of H blanking pulse in microseconds?

  • A. 5
  • B. 0.93
  • C. 10.2
  • D. 53.5

76. What are the approximate time periods for the visible H trace?

  • A. 5
  • B. 0.93
  • C. 10.2
  • D. 53.5

77. What are the approximate time periods for the width of H sync pulse?

  • A. 5
  • B. 0.93
  • C. 10.2
  • D. 53.5

78. Which pulses in V blacking correspond to the 3H lines wide?

  • A. V sync
  • B. V blanking
  • C. Equalizing
  • D. all of the above

79. Which pulses in V blanking correspond to the 21H lines wide?

  • A. V sync
  • B. V blanking
  • C. Equalizing
  • D. all of the above

80. Which pulses in V blacking correspond to the 31,500 Hz?

  • A. V sync
  • B. V blanking
  • C. Equalizing
  • D. all of these

81. Give the maximum number of picture details for each horizontal line.

  • A. 338
  • B. 426
  • C. 125,000
  • D. 144,000

82. Give the maximum number of picture details for total picture area.

  • A. 338
  • B. 426
  • C. 125,000
  • D. 144,000

83. The average dc level is close to the blanking level for a scene?

  • A. light
  • B. dark
  • C. either dark or light
  • D. neither dark nor light

84. In what condition does the picture tube reproduce black?

  • A. maximum beam current
  • B. minimum beam current
  • C. zero beam current
  • D. none of these

85. The gamma effects the of the picture tube.

  • A. contrast
  • B. Brightness
  • C. dullness
  • D. either the brightness or contrast

86. Picture tube has games which is .

  • A. greater than 1
  • B. less than 1
  • C. infinity
  • D. zero

87. Brightness variations of the picture information are in which signal?

A. 1

B. Q

C.Y

D. R-Y

88. The hue 180º out of phase with red is

  • A. cyan
  • B. yellow
  • C. green
  • D. blue

89. Greater p-p amplitude of the 3.58MHz chrominance signal indicates more

  • A. white
  • C. hue
  • B. yellow
  • D. saturation

90. The interfering beat frequency of 920 kHz is between the 3.58 MHz color subcarrier and the

  • A. 4.5 MHz intercarrier sound
  • B. picture carrier
  • C. lower adjacent sound
  • D. upper adjacent picture

91. The hue of color sync phase is

  • A. red
  • B. cyan
  • C. blue
  • D. yellow-green

92. Which signal has color information for 1.3 MHz bandwidth?

  • A. I
  • B. Y
  • C. R-Y
  • D. B-Y

93. Which of the following is false?

  • A. the I video hues are orange or cyan
  • B. The transmitter matrix output includes Y, I, and Q video
  • C. A three-gun picture tube that can serve as a matrix.
  • D. a fully saturated color is mostly white

94. The color with the most luminance is

  • A. red
  • B. yellow
  • C. green
  • D. blue

95. What is the hue of a color 90º leading sync burst phase?

  • A. yellow
  • B. cyan
  • C. Blue
  • D. Orange

96. The average voltage value of the 3.58 MHz modulated chrominance signal is

  • A. zero for most colors
  • B. close to black for yellow
  • C. the brightness of the color
  • D. the saturation of the color

97. The second IF value for color in receivers, for any station, is

  • A. 0.5 MHz
  • B. 1.3 MHz
  • C. 3.58 MHz
  • D. 4.5 MHz

98. if the 3.58-MHz C amplifier in the receiver does not operate, the result will be

  • A. no color
  • B. no red
  • C. too much blue
  • D. too much yellow

99. How many octaves is the frequency range 1 to 8MHz?

  • A. 1
  • B. 2
  • C. 3
  • D. 8

100. Which system can be used for both recording and playback?

  • A. CEO
  • B. VHD
  • C. Laser disk
  • D. VHS

SEE ALSO: Complete List of Basic Television - Grob TV Chapter Exercises

Complete List of MCQs in Electronics Engineering per topic


Search! Type it and Hit Enter


We educate thousands of students a week in preparation for their licensure examinations. We provide professionals with materials for their lectures and practice exams. To help us go forward with the same spirit, contribution from your side will highly appreciated. Thank you in advance.


Post a Comment

Emoticon
:) :)) ;(( :-) =)) ;( ;-( :d :-d @-) :p :o :>) (o) [-( :-? (p) :-s (m) 8-) :-t :-b b-( :-# =p~ $-) (b) (f) x-) (k) (h) (c) cheer
Click to see the code!
To insert emoticon you must added at least one space before the code.

Contact Form

Name

Email *

Message *

Powered by Blogger.
Javascript DisablePlease Enable Javascript To See All Widget