
This is the Online Practice Quiz in Digital and Data Communication Networks Part 2 as one of the Communications Engineering topic. In Preparation for the ECE Board Exam make sure to expose yourself and familiarize in each and every questions compiled here taken from various sources including but not limited to past Board Examination Questions in Electronic System and Technologies, Communications Books, Journals and other Communications References.
Continue Part II of the Online Practice Quiz
Quiz in Digital and Data Communication Networks
Question 11. For an Ethernet bus that is 500 meters in length using a cable with a velocity factor of 0.66, and a communication rate of 10 Mb/s, calculate the total number of bits that would be sent by each station before it detects a collision, if both stations begin to transmit at the same time.
Question 12. What is the bandwidth required to transmit at a rate of 10Mbits/sec in the presence of a 28 dB S/N ratio?
Question 13. Which of the following modulation techniques are used by modems?
Question 14. In the EIA-RS-232 standard what does -12V on a data pin represent?
Question 15. The majority of the pins of the EIA-RS-232 interface are used for _____ purpose.
Question 16. 12 voice channels are sampled at 8000 sampling rate and encoded into 8-bit PCM word. Determine the rate of the data stream.
Question 17. Deliberate violations of alternate mark inversion are used in which type of digital-to-digital encoding?
Question 18. Which of the following modems uses FSK modulation?
Question 19. The EIA-RS-232 interface has _______ pins.
Question 20. Which encoding method uses alternating positive and negative values for 1’s? |
List of Practice Quizzes
Post a Comment
Click to see the code!
To insert emoticon you must added at least one space before the code.