This is the Multiple Choice Questions in Chapter 7: Digital Communications from the book Electronic Communication Systems by Roy Blake
Start Practice Exam Test Questions
Choose the letter of the best answer in each questions.
MULTIPLE CHOICE
1. The first digital code was the:
- a. ASCII code
- b. Baudot code
- c. Morse code
- d. none of the above
ANS: C
2. In digital transmission, signal degradation can be removed using:
- a. an amplifier
- b. a filter
- c. a regenerative repeater
- d. all of the above
ANS: C
3. TDM stands for:
- a. Time-Division Multiplexing
- b. Time-Domain Multiplexing
- c. Ten-Digital Manchester
- d. Ten Dual-Manchester
ANS: A
4. Hartley's Law is:
- a. I = ktB
- b. C = 2B log2M
- c. C = B log2(1 + S/N)
- d. SR = 2fmax
ANS: A
5. The Shannon-Hartley theorem is:
- a. I = ktB
- b. C = 2B log2M
- c. C = B log2(1 + S/N)
- d. SR = 2fmax
ANS: B
6. The Shannon Limit is given by:
- a. I = ktB
- b. C = 2B log2M
- c. C = B log2(1 + S/N)
- d. SR = 2fmax
ANS: C
7. The Nyquist Rate can be expressed as:
- a. I = ktB
- b. C = 2B log2M
- c. C = B log2(1 + S/N)
- d. SR = 2fmax
ANS: D
8. Natural Sampling does not use:
- a. a sample-and-hold circuit
- b. true binary numbers
- c. a fixed sample rate
- d. an analog-to-digital converter
ANS: A
9. Which is true about aliasing and foldover distortion?
- a. They are two types of sampling error.
- b. You can have one or the other, but not both.
- c. Aliasing is a technique to prevent foldover distortion.
- d. They are the same thing.
ANS: D
10. Foldover distortion is caused by:
- a. noise
- b. too many samples per second
- c. too few samples per second
- d. all of the above
ANS: C
11. The immediate result of sampling is:
- a. a sample alias
- b. PAM
- c. PCM
- d. PDM
ANS: B
12. Which of these is not a pulse-modulation technique:
- a. PDM
- b. PWM
- c. PPM
- d. PPS
ANS: D
13. Quantizing noise (quantization noise):
- a. decreases as the sample rate increases
- b. decreases as the sample rate decreases
- c. decreases as the bits per sample increases
- d. decreases as the bits per sample decreases
ANS: C
14. The dynamic range of a system is the ratio of:
- a. the strongest transmittable signal to the weakest discernible signal
- b. the maximum rate of conversion to the minimum rate of conversion
- c. the maximum bits per sample to the minimum bits per sample
- d. none of the above
ANS: A
15. Companding is used to:
- a. compress the range of base-band frequencies
- b. reduce dynamic range at higher bit-rates
- c. preserve dynamic range while keeping bit-rate low
- d. maximize the useable bandwidth in digital transmission
ANS: C
16. In North America, companding uses:
- a. the Logarithmic Law
- b. the A Law
- c. the α Law (alpha law)
- d. the µ Law (mu law)
ANS: D
17. In Europe, companding uses:
- a. the Logarithmic Law
- b. the A Law
- c. the α Law (alpha law)
- d. the µ Law (mu law)
ANS: B
18. Codec stands for:
- a. Coder-Decoder
- b. Coded-Carrier
- c. Code-Compression
- d. none of the above
ANS: A
19. A typical codec in a telephone system sends and receives:
- a. 4-bit numbers
- b. 8-bit numbers
- c. 12-bit numbers
- d. 16-bit numbers
ANS: B
20. Compared to PCM, delta modulation:
- a. transmits fewer bits per sample
- b. requires a much higher sampling rate
- c. can suffer slope overload
- d. all of the above
ANS: D
21. In delta modulation, "granular noise" is produced when:
- a. the signal changes too rapidly
- b. the signal does not change
- c. the bit rate is too high
- d. the sample is too large
ANS: B
22. Compared to PCM, adaptive delta modulation can transmit voice:
- a. with a lower bit rate but reduced quality
- b. with a lower bit rate but the same quality
- c. only over shorter distances
- d. only if the voice is band-limited
ANS: B
23. Which coding scheme requires DC continuity:
- a. AMI
- b. Manchester
- c. unipolar NRZ
- d. bipolar RZ
ANS: C
24. Manchester coding:
- a. is a biphase code
- b. has a level transition in the middle of every bit period
- c. provides strong timing information
- d. all of the above
ANS: D
25. The number of framing bits in DS-1 is:
- a. 1
- b. 2
- c. 4
- d. 8
ANS: A
26. Framing bits in DS-1 are used to:
- a. detect errors
- b. carry signaling
- c. synchronize the transmitter and receiver
- d. all of the above
ANS: C
27. So-called "stolen" bits in DS-1 are used to:
- a. detect errors
- b. carry signaling
- c. synchronize the transmitter and receiver
- d. all of the above
ANS: B
28. The number of bits per sample in DS-1 is:
- a. 1
- b. 2
- c. 4
- d. 8
ANS: D
29. The number of samples per second in DS-1 is:
- a. 8 k
- b. 56 k
- c. 64 k
- d. 1.544 x 106
ANS: A
30. The bit rate for each channel in DS-1 is:
- a. 1.544 Mb/s
- b. 64 kb/s
- c. 56 kb/s
- d. 8 kb/s
ANS: B
31. In DS-1, bits are transmitted over a T-1 cable at:
- a. 1.544 MB/s
- b. 64 kb/s
- c. 56 kb/s
- d. 8 kb/s
ANS: A
32. A T-1 cable uses:
- a. Manchester coding
- b. bipolar RZ AMI coding
- c. NRZ coding
- d. pulse-width coding
ANS: B
33. The number of frames in a superframe is:
- a. 6
- b. 12
- c. 24
- d. 48
ANS: B
34. A typical T-1 line uses:
- a. twisted-pair wire
- b. coaxial cable
- c. fiber-optic cable
- d. microwave
ANS: A
35. "Signaling" is used to indicate:
- a. on-hook/off-hook condition
- b. busy signal
- c. ringing
- d. all of the above
ANS: D
36. A vocoder implements compression by:
- a. constructing a model of the transmission medium
- b. constructing a model of the human vocal system
- c. finding redundancies in the digitized data
- d. using lossless techniques
ANS: B
37. Compared to standard PCM systems, the quality of the output of a vocoder is:
- a. much better
- b. somewhat better
- c. about the same
- d. not as good
ANS: D
COMPLETION
1. Digitizing a signal often results in ____________________ transmission quality.
ANS:
improved
better
2. To send it over an analog channel, a digital signal must be ____________________ onto a carrier.
ANS: modulated
3. To send it over a digital channel, an analog signal must first be ____________________.
ANS: digitized
4. In analog channels, the signal-to-noise ratio of an analog signal gradually ____________________ as the length of the channel increases.
ANS:
decreases
gets worse
5. The ____________________ value of a pulse is the only information it carries on a digital channel.
ANS: binary
6. A ____________________ repeater is used to restore the shape of pulses on a digital cable.
ANS: regenerative
7. There are techniques to detect and ____________________ some errors in digital transmission.
ANS: correct
8. Converting an analog signal to digital form is another source of ____________________ in digital transmission systems.
ANS:
error
noise
9. ____________________-division multiplexing is easily done in digital transmission.
ANS: Time
10. All practical communications channels are band-____________________.
ANS: limited
11. ____________________ Law gives the relationship between time, information capacity, and bandwidth.
ANS: Hartley's
12. Ignoring noise, the _________________________ theorem gives the maximum rate of data transmission for a given bandwidth.
ANS: Shannon-Hartley
13. The ____________________ limit gives the maximum rate of data transmission for a given bandwidth and a given signal-to-noise ratio.
ANS: Shannon
14. ____________________ sampling is done without a sample-and-hold circuit.
ANS: Natural
15. The ____________________ Rate is the minimum sampling rate for converting analog signals to digital format.
ANS: Nyquist
16. ____________________ distortion occurs when an analog signal is sampled at too slow a rate.
ANS: Foldover
17. ____________________ means that higher frequency baseband signals from the transmitter "assume the identity" of low-frequency baseband signals at the receiver when sent digitally.
ANS: Aliasing
18. The output of a sample-and-hold circuit is a pulse-____________________ modulated signal.
ANS: amplitude
19. ____________________ modulation is the most commonly used digital modulation scheme.
ANS: Pulse-code
20. ____________________ noise results from the process of converting an analog signal into digital format.
ANS: Quantizing
21. ____________________ is used to preserve dynamic range using a reasonable bandwidth.
ANS: Companding
22. In North America, compression is done using the ____________________-law equation.
ANS:
µ
mu
23. In Europe, compression is done using the ____________________-law equation.
ANS: A
24. A ____________________ is an IC that converts a voice signal to PCM and vice versa.
ANS: codec
25. In a PCM system, the samples of the analog signal are first converted to ____________________ bits before being compressed to 8 bits.
ANS: 12
26. The number of bits per sample transmitted in delta modulation is ____________________.
ANS:
1
one
27. Delta modulation requires a ____________________ sampling rate than PCM for the same quality of reproduction.
ANS: higher
28. ____________________ noise is produced by a delta modulator if the analog signal doesn't change.
ANS: Granular
29. In delta modulation, ____________________ overload can occur if the analog signal changes too fast.
ANS: slope
30. The ____________________ size varies in adaptive delta modulation.
ANS: step
31. Adaptive delta modulation can transmit PCM-quality voice at about ____________________ the bit rate of PCM.
ANS: half
32. Unipolar NRZ is not practical because most channels do not have ____________________ continuity.
ANS: DC
33. In AMI, binary ones are represented by a voltage that alternates in ____________________.
ANS: polarity
34. Long strings of ____________________ should be avoided in AMI.
ANS: zeros
35. Manchester code has a level ____________________ in the center of each bit period.
ANS: transition
36. Manchester coding provides ____________________ information regardless of the pattern of ones and zeros.
ANS: timing
37. There are ____________________ channels in a DS-1 frame.
ANS: 24
38. DS-1 uses a ____________________ bit to synchronize the transmitter and receiver.
ANS: framing
39. In DS-1, each channel is sampled ____________________ times per second.
ANS: 8000
40. Data is carried over a T-1 line at a rate of ____________________ bits per second.
ANS: 1.544 x 106
41. A group of 12 DS-1 frames is called a ____________________.
ANS: superframe
42. From a group of twelve frames, signaling bits are "stolen" from every ____________________ frame.
ANS: sixth
43. ____________________ compression transmits all the data in the original signal but uses fewer bits to do it.
ANS: Lossless
SHORT ANSWER
1. Use Hartley's Law to find how much time it would take to send 100,000 bits over a channel with a bandwidth of 2,000 hertz and a channel constant of k = 10.
ANS:
5 seconds
2. Use the Shannon-Hartley theorem to find the bandwidth required to send 12,000 bits per second if the number of levels transmitted is 8.
ANS:
2000 hertz
3. What is the Shannon Limit of a channel that has a bandwidth of 4000 hertz and a signal-to-noise ratio of 15?
ANS:
16 kbps
4. What is the minimum required number of samples per second to digitize an analog signal with frequency components ranging from 300 hertz to 3300 hertz?
ANS:
6600 samples/second
5. What is the approximate dynamic range, in dB, of a linear PCM system that uses 12 bits per sample?
ANS:
74 dB
6. What is the approximate data rate for a system using 8 bits per sample and running at 8000 samples per second?
ANS:
64 kbps
7. If bits were "stolen" from every DS-1 frame, what would the useable data-rate be for each channel in the frame?
ANS:
56 kbps
8. Assuming maximum input and output voltages of 1 volt, what is the output voltage of a µ-law compressor if the input voltage is 0.388 volt?
ANS:
0.833 volt
Post a Comment